First, I want to show my idea of another project, a deck mounted vent for a new head.
I ordered a piece of teak from Buck Woodcraft that was 2" x 5" x 12". The piece I got was pretty nice too.
I cut it down to a 5" square that I will shape to the curve of the deck. I also plan to install a Vetus Mushroom vent to it. Others have mentioned I should use a dorade box, but this way I'm going will be lower profile and I think better suited for my boat. I mainly placed the block to show size and placement.
The main project was to clean the fuel filters. I found some nice instructions for the Racor fuel filters from a guy known on boating forums as Maine Sail. What was nice is the picture showing the gaskets and what they go to. I guess the seal kit was supposed to come with it but the two kits I got didn't have it. I printed the picture and placed the gaskets over it to make sure I had everything ready.
I had some junk sitting at the bottom of the port side filter. Once I had the bowl and housing apart, cleaning it wasn't too bad except for a few tight spaces near the plugs at the bottom of the bowl.
 |
| Port side filter |
Everything for the starboard side filter went well too. It just had a lot more debris sitting in the bowl. The worst thing was the fuel ended up being black when it was drained as the debris was breaking up and dropping into the jar too. The fuel didn't look too bad when it was sitting in the bowl, just looked worse when it was drained.
 |
| Starboard side filter |
 |
| Black fuel |
It just shows the importance of regular maintenance or servicing something when it needs it. I think debris like this could have made its way into the engine causing it to stall. Definitely not a good thing if the engine is needed in a hurry. Since getting the 3gal tank, the engine has seemed to run better with cleaner fuel, so hopefully cleaner filters will help too to keep it running.
The last thing I did for the day was to mix up some epoxy with some low density filler to cover the hole left over from the old holding tank vent. I put enough on it so I can sand it down flush with the surrounding surface. Sometime in the future, I'm looking at repainting the blue stripe so this little patch will then be covered up.
