Saturday, August 2, 2014

Some Dis-Assembly Required

Part of this refit is to break things down in order to build it back up again.

I'm looking at doing a few things at the same time. I want to repaint the blue near the toe rail to a dark red. Not sure what type of paint to use yet. I've looked at Interlux Brightsides, Pettit Easypoxy, Awlgrip and whatever else I can find. Brightsides has "Fire Red" but to darken, would require some mixing. Awlgrip and Easypoxy has dark red and due to costs, I'm leaning toward Easypoxy, unless I find something else or a different kind is suggested.

In order to prepare for this, I removed the name off of the port side, not yet on the starboard. There was a sticky residue left over after I scraped off the letters. I looked up online what could be used and saw something about acetone. I tried it and it cleaned it up nicely.


sticky residue left behind after scraping

after acetone cleaning

I also used an electrical palm sander a little bit. There was a spot that sanded through to a darker color underneath and a spot that was chipped. I'll have to sand down some more but not sure how far to go at the moment. What ever was used for the current color, there was a little bit of a reflection on it. I might sand it smooth, put on some primer and put whatever I get over it. With a new color, I can then add new set of letters for the name, whenever I get some.

Sanded through to a darker blue

I plan on replacing the chainplates. Not because they're bad. Actually, they don't look too bad but they're old and for preventative measures it's good to make sure they're updated. Removing them from the hull sides, it will give the repainting an even surface.


Removing stern chainplates
The sides were not as accessible. I had to remove the panels to get to the bolts for two of the side chainplates. The same way on both sides. The big washers on the sides were epoxied into place so they're not coming off. After getting the chainplates off, I just needed to scrape some of the caulking that was used off the boat and the chainplate.



 


The third chainplates on each side will be a bit more difficult. The panels are not setup in a way to pop off or slide out of the way. Looks like I might have to cut away some of the paneling and add some trim to hide the cut. At least that's an idea I have. One side, I have the galley and the other side, I have the nav desk. The panels behind each extend behind another piece of wood or bulkhead. So creativity is needed.


Overall, I got the two stern chainplates and two from each side off. I still have the third chainplate on each side and the one on the bow to remove.

So, some disassembly required.


4 comments:

  1. Its always a bit unnerving having to take things apart and make them look worse so that you cam make them look and function better in the long run. Rhapsody will thank you for all of the care and attention you are giving her. Keep at it and you will be finished before you know it.

    ReplyDelete
    Replies
    1. You're right, it is a bit unnerving. The planning still continues too, like refinishing the mast, replacing seacocks, replacing the fuel tank... there's plenty to take apart but it'll be better once all together again.

      Delete
  2. Every project I have done, taking this apart seems to be the worst part. Once apart you can clean and replace...making re-assembly a breeze.
    Good luck with your refit

    ReplyDelete
    Replies
    1. Thanks. I'm looking forward to the refit and learning new skills along the way and learning more about my boat.

      Delete