Showing posts with label Iron Sail. Show all posts
Showing posts with label Iron Sail. Show all posts

Sunday, December 13, 2015

State of the Engine

As I'm looking over the engine, I took pictures to show how much work will need to be done. The main areas of visible damage seem to come from a few sources but that has cascaded into more work elsewhere. As they say, everything rolls down hill. For example, it looks like the gasket for the exhaust mixer failed so that caused rust going down to the zinc below it, likely to the fuel pump below that, and made its way toward the dipstick. I at least haven't seen any water when doing the last oil change, but that was a few years ago by now. That side zinc won't budge right now so some extra work will be needed there.

Another area at the back at the aft zinc (there's only 2 on this engine), there's some oil there. I believe this is from the failed valve cover gasket that I had fixed before. That zinc cap won't budge either. I have PB Blaster I can use to see if that will help.

Water had previously leaked from the engine panel down to the top/front of the engine. That shouldn't be too bad, but will still need some cleaning up. The thermostat cover seems to have had a leak before too, and I'm looking to replace that and the mounting bolts/gaskets and maybe the thermostat itself. Another Nor'sea owner suggested I remove the injectors just so that I can. Otherwise, doing it later can be a pain. But, if I'm not able to, it may have to be removed at a shop anyway. Other hoses, pipes, gaskets, and bolts will be replaced as well. I have a parts catalog and shop manual on hand on the computer and will be going over them to get a list together.

Just the engine itself is plenty of work. But the main reason I pulled it out in the first place, was to replace the fuel tank, which has just begun.

current state in the cabin

exhaust elbow, below is one engine zinc

the other engine zinc



fuel pump

surface rust hasn't been there long


thermostat cover

the rust line coming from the exhaust mixer above

fuel pump to the left, side zinc in the center

exhaust mixer mounting



thermostat cover again, to be replaced w/bolts



inside of exhaust mixer



Not much, but it's a start to removing the fuel tank. Doesn't look to me like fiberglass was used, just resin holding the tank. Some parts was maybe 1/8" thick and the aft area was closer to 1/4" or slightly more. Using an oscillating cutting tool, a screw driver, and a 3lb sledge hammer, it's coming out well enough. Then, the foam underneath will be torn out as well.





Friday, April 20, 2012

Yanmar 2GM

Taking a look at the engine, it physically looks pretty good. I'll eventually need to learn engines and engine repair, just in case. Here's a few pictures of how everything looks.




I happened to find a maintenance book from a previous owner. There is some good logs of when oil was checked/replaced, when things like filters and belts were replaced and engine hours of when work was done and other maintenance along the way. It'll be good reference to see what might need to be worked on once I get to this point.

UPDATE 27 April 2012

Additional pictures around the engine.

This is the water pump. I plan to check the impeller to see its condition.


A couple filters.



Back side of the instrument panel.


Looking for the starboard quarter berth access panel. Not the easiest place to get to the oil dipstick. There isn't much room to move around.



Overall the engine looks to be in good condition. there are a few places where the hoses are at, like to the impeller that shows water has corroded a little bit of the parts. Also the shaft, where just before it goes through the hull to the propeller is also showing signs of corrosion.