Pages

Sunday, November 11, 2012

Varnish Part... (Nevermind)

I started a college class this past week, English 102, that will last until end of December. I'm not too crazy about it but if I'm ever going to get a degree, I need it. So, this leaves less time for boat related work (or anything else for that matter). But I'll fit it in some how.

Yesterday and today, I painted the starboard side handrail and I think I built enough varnish on it to be even with the port side. I started the port side before so I was working on getting them even now. To me, it looks like I got enough to build them up a few more coats without using mineral spirits to thin out the varnish, then I should be done with them. Then the tricky part of mounting them back on the boat.

Between the varnish work I did yesterday and today, I went through the same process. The weather was nice to work on it on the back deck both days. I sanded down the handrail with 220 grit sand paper then used my small shop-vac to vacuum up the dust. The varnish was still cut a little with mineral spirits, what I had left over from the other day. I applied varnish down the whole handrail. I measured it the other day while it was sitting in the living room. This rail is 11 ft long. By the time I got to the end of the handrail, I checked where I started and it was already drying. It wasn't just sticky but actually dry to the touch. I decided to apply another coat and let it dry. When this second coat dried to the touch, I moved it to the living room to dry the full 24hrs recommended on the varnish can. All of this, each day, probably didn't take more than 30 min to do.

Like I said, I did the same process yesterday and today. I'll get another few coats of straight varnish and it should be ready for the boat.

Here's pictures to show how it came out. I really like how the grain shows up on this handrail since I did use teak cleaner/brightener.




And this is showing it spread out in the living room. The wrenches hold the rails up by its bolts while it drys for the full 24hrs. The other pieces shown are the port side rails (came in two pieces) that are laying down waiting for the next coats of varnish.

2 comments:

  1. Looks great! I love the idea of using that screw or bolt to hold the rail up while you varnish over the whole thing.

    ReplyDelete
    Replies
    1. holding the rail up by the bolts is nice so that the rail doesn't fall over and get varnish all over the place where it shouldn't. :)

      Delete